Kinsler_Handbook_#32 December 2017

Kinsler Fuel Injection, Inc, 1834 THUNDERBIRD TROY, MICHIGAN 48084 U.S.A. www.Kinsler.com Phone (248) 362-1145 Fax (248) 362-1032 84 KINSLER QUICK DISCONNECT BYPASS VALVE Be sure to shut off the engine before pulling apart the jet can, or fuel spillage will occur. CAUTION When you drop the jet into the end cap, be sure the number is facing you NOTE There is no one o-ring compound that works well for gasoline, methanol, and nitromethane. We therefore use one o-ring compound in the gas and methanol jet cans, and a different compound in the alcohol/nitro jet cans. Using a fuel or additive other than that specified may cause swelling of the main body o-ring, or leakage due to shrinkage of the o-rings. When the main body o-ring swells, it may be difficult to uncouple the valve. Contact us for the proper o-rings if a fuel other than the ones specified is being used. Valve can be used for other applications by using different spring and shim combinations. (For springs and shims see Page #85 BYPASS VALVES) The quick disconnect bypass with hoses attached. Note: collar is rotated so that the notch is not aligned with the pin; prevents accidental opening of the valve The collar being pulled back after the notch is aligned with the pin Use a twisting motion while pulling the valve apart The two parts of the assembly are separated, with the jet in the end cap on the right, the jet is merely dropped out and the new one is inserted NO WRENCHES NEEDED !!! Simply slide back the outer collar, pull the main bodies apart, and change the jet CAN BE USED ON ANY MAKE OF INJECTION UNIT : ACCEPTS Kinsler K-type or Hilborn jets. Valve has 6 AN male flare ends and has a fully machined, hard anodized, stick-free poppet. FAST and EASY JET CHANGES Kinsler, Hilborn, Crower, Enderle, Ron’s, Jackson, etc. © 2017 3104 Red and gold anodized aluminum, 6 AN male flare, for gasoline 3112 Hard-anodized aluminum, model: Ano-QD, 6 AN male flare, for gasoline and methanol 3115 Same as #3112 but with o-rings for use with nitromethane 3101 End cap, for quick disconnect, hard-anodized, includes jet sealing o-ring 3036 Poppet, Kinsler hard-anodized, for Kinsler and Hilborn 6 AN jet can 3319 Spring, .019" wire diameter, standard spring for Kinsler main bypass valve 3116 O-ring, jet sealing, for end cap #3006, #3104, and #3112 3117 O-ring set, for quick disconnect, gasoline and methanol ONLY 3119 O-ring set, for quick disconnect, nitromethane ONLY

RkJQdWJsaXNoZXIy ODE2MjA=