Kinsler_Handbook_#32 December 2017

189 1834 THUNDERBIRD TROY, MICHIGAN 48084 U.S.A. www.Kinsler.com Phone (248) 362-1145 Fax (248) 362-1032 Kinsler Fuel Injection, Inc, CHECK VALVES Aircraft grade hinged-flap “toilet seat” check valve makes this a choice for roll-over valves, multiple tank fuel systems, or anti-back flow valve. Hinged-flap has captive o-ring for excel- lent seal when closed. CHECK VALVES - FLAPPER 3090 4 AN male flare inlet & outlet 3091 6 AN male flare inlet & outlet 3092 8 AN male flare inlet & outlet 3097 10 AN male flare inlet & outlet 3098 12 AN male flare inlet & outlet 3093 3/4" NPT male inlet x 3/4" NPT female outlet 3094 16 AN male flare inlet & outlet 3095 20 AN male flare inlet & outlet ONE WAY CHECK VALVE Ideal for pressure capturing equipment or low volume one-way flow to a nozzle, primer system, etc. 3048 1/8" NPT male inlet and outlet, brass, 1-PSI nominal opening pressure, gasoline and methanol only, 1.3" overall length 3049 1/4" NPT male inlet and outlet, brass, 1-PSI nominal opening pressure, gasoline and methanol only, 1.59" overall length #3049 © 2017 This 6 AN valve has an o-ringed poppet for positive sealing. Flows 1000 lbs/hr with a 2 PSI pressure drop for a very low restriction. Valve has 0.5 PSI nominal opening pressure. 3096 Bubble tight one-way check valve, 6 AN male flare inlet and outlet BUBBLE TIGHT CHECK VALVE 8102 Valve assembly with 6 AN male outlet and two 6 AN male flare check inlets 8101 Valve assembly with 8 AN male outlet and two 8 AN male flare check inlets 8100 Body ONLY, can be used as 8 AN female tee BOOST PRESSURE CAPTURING ASSEMBLY For monitoring maximum manifold pressure (boost) without watching the gauge. Assembly is setup with one-way check valve, glyc- erin filled pressure gauge,and push button pressure release. 5931 Boost pressure gauge assembly; uses #3048 check valve, 1/8" NPT, specify 0-30 or 0-60 PSI gauge 5932 Boost pressure gauge assembly; uses #3049 check valve, 1/4" NPT, specify 0-30 or 0-60 PSI gauge #5931 #5932 3-WAY CHECK VALVE Unit allows for two separate inlets to feed one outlet. A check valve on each inlet allows either supply to be utilized, while restricting back flow through the supply not in use. Billet aluminum housing, blue anodized, 8 AN female ports, mounting ear with clearance hole for a 1/4” bolt. This type of valve assembly is run on many Lucas Mechanical injection systems (see Pages #205- 213). Those systems feature an electric starting pump and a mechanical engine driven pump. This assembly can also be installed when using two eletric pumps. REPLACEMENT FLAPPER ASSEMBLY 3140 4 AN 3141 6 AN 3142 8 AN 3143 10 AN 3144 12 AN Includes: flap- per plate with seal, spring, and pin only, does not in- clude fitting. Check inlet fit- ting

RkJQdWJsaXNoZXIy ODE2MjA=