Kinsler_Handbook_#32 December 2017

174 Kinsler Fuel Injection, Inc, 1834 THUNDERBIRD TROY, MICHIGAN 48084 U.S.A. www.Kinsler.com Phone (248) 362-1145 Fax (248) 362-1032 DRIVES FOR MECHANICAL PUMP FRONT COVER FUEL PUMP DRIVE - KITS AND PARTS KINSLER FRONT COVER FUEL PUMP DRIVE KIT FOR USE WITH JESEL CAM DRIVE Available for small and big block Chevrolet, standard and raised cam (see below). Allows mechanical fuel pump or shorty ignition distributor (see Pg. 219) to be run off the front of the cam. Clearance holes in mounting plate allow adjustment of cam timing without removing plate. Unit attachs to water outlet ports on block. Our spacers are hollow. Block off plates can be drilled and tapped for access to water. Kits are complete with all hardware and gaskets. Components are available separately. © 2017 5280 Small block Chevrolet, standard deck, complete kit 5282 Small block Chevrolet, raised cam +.391", complete kit 5283 Big block Chevrolet, standard deck, complete kit 5285 Big block Chevrolet, raised cam +.400", complete kit 5286 Drive spud, left hand thread, 3/8" female hex #5204 #5203 #5200 #5201 5200 Chevrolet small block V-8, aluminum cover with spud, bearing, and shims 5201 Chevrolet big block V-8, aluminum cover with spud, bearing, and shims 5202 Ford 289 small block V-8, aluminum cover with spud, bearing, and shims 5205 Front cover ONLY, Chevrolet small block V-8, cast aluminum 5206 Front cover ONLY, Chevrolet big block V-8, cast aluminum 5210 Drive spud, Chevrolet V-8 camshaft, 3/8" female hex drive, 3-bolt 5211 Drive spud, Chrysler Hemi V-8 camshaft, 3/8" female hex drive, 3-bolt 5212 Shim kit, for drive spuds #5210 and #5211 5213 Thrust bearing, for drive spuds #5210 and #5211 5214 Drive spud, Ford 289 small block V-8, 3/8" female hex drive 5203 Hilborn: Chevrolet small block V-8, complete with cover, spud, bearing, and shims 5204 Hilborn: Chevrolet big block V-8, complete with cover, spud, bearing, and shims 5226 Hilborn drive spud, Chevrolet V-8 camshaft, 3-bolt 5227 Hilborn shim kit for #5226 5228 Bearing for #5226 Small block Chevrolet Big block Chevrolet Install shims so that the cam end clearance is .010” to .020”. The smaller clearance is preferred to minimize spark scatter. SETUP Drive spuds Bearing Shims

RkJQdWJsaXNoZXIy ODE2MjA=