Kinsler_Handbook_#32 December 2017

Kinsler Fuel Injection, Inc, 1834 THUNDERBIRD TROY, MICHIGAN 48084 U.S.A. www.Kinsler.com Phone (248) 362-1145 Fax (248) 362-1032 147 TPS rotation is determined while looking at the end of the throttle shaft Connector Assembly 10403 3 pin, flat, Weather Pack, to fit GM TPS clockwise rotation counter- clockwise rotation 10685 TPS, GM style, model 'D', adjustable, clockwise rotation 10686 TPS, GM style, model 'D', adjustable, counter-clockwise rotation 7095 Bolt-on TPS adapter boss, for GM style TPS 7090 Drive dog; for GM style TPS GM Style Sensors THROTTLE POSITION SENSORS (TPS) AND ACCESORIES © 2017 #10686 #7095 #7090 #10685 GM style TPS, adapter boss and drive dog installed on Kinsler four barrel throttle body All Kinsler bolt-on TPS adapter bosses are .500” C-C upper mount hole to throttle shaft and .587” C-C lower mount hole to throttle shaft. All of our manifold ends are drilled and tapped with these two bolt holes. All Kinsler drive dogs are made for a 3/8” diameter shaft #7095 with #7090 The TPS is a potentiometer actuated by a throttle shaft. The ECU supplies a constant 5 volts to the TPS which sends a 0-5 volt signal back, proportional to throttle opening. The ECU uses this signal to find the proper fuel rate in it’s basic fuel 7071 Bolt-on TPS adapter boss, for LS1 style TPS 7072 Drive dog, for LS1 style TPS #7071 #7072 #7071 with #7072 Example of LS1 style TPS Kinsler Dragon Claw with bolt-on TPS adapter and TPS Kinsler 4-barrel throttle body with bolt-on TPS adapter and TPS #7097 #10689 10689 TPS, GM/CTS twin groove/tang style, counter-clockwise rotation 7097 Bolt-on TPS adapter boss, for #10689 TPS 7077 Drive dog, for #10689 TPS #7077 #7097 with #7077

RkJQdWJsaXNoZXIy ODE2MjA=